Reflector holder rear light holder 140x21 (reflector 100x13) black - nylon carbon fibre Quad Yamaha Raptor, Banshee, Suzuki, Kawasaki, E-ATV etc.

Reflector holder rear light holder 140x21 (reflector 100x13) black - nylon carbon fibre Quad Yamaha Raptor, Banshee, Suzuki, Kawasaki, E-ATV etc.

‘’ NEW VERSION -- EVEN EASIER INSTALLATION’

Everyone knows it, nobody wants it! The time of ugly metal plates and huge reflectors is now over!
 

The offer is valid for 2 holders incl. E-approved reflectors

The pictures with LED rear light are for illustration purposes only. Item is expressly supplied without rear lights!

E-approved reflector included!
 
Scope of delivery:

    2x bracket
    2x reflector (pre-assembled)

DELIVERY IS EXPRESSLY WITHOUT REAR LIGHT / INDICATOR!
-------------------------

Mounting instructions:

    Commercially available M8 screws can be used for mounting
    Design suitable for all commercially available rear lights / indicators with M8 thread
    Indicator / rear light is secured with a grub screw! (Very easy installation!)
    Indicators / tail lights are secured in the holder with a grub screw.


--------------------

Product characteristics:

    Good mechanical properties
    Good chemical resistance
    Resistant to most greases, oils and commercially available chemicals
    Weatherproof and UV-resistant

    The holders have a cable feed-through on the underside (alternatively on the top). The cable is fed out from the inside in the centre and then to the side. Hidden in a groove and glued or secured with a cable tie, the cable is almost invisible.

--------------------
 
Dimensions:

    Bracket = 138mm x 21mm
    Reflector = 100mm x 13mm

--------------------
 
Weight:

    Weight incl. the rear light shown: 58 grams (varies depending on the rear light)
    Weight of bracket incl. reflector: 34 grams

    Therefore very little load on the mounting point and can be mounted almost anywhere

--------------------

Further information:

    Material (PU) is paintable after appropriate pre-treatment
    The holders are supplied pre-assembled with the reflector. If this is not desired, please let us know at the time of purchase

--------------------

Instructions for use:

    Can be used for all quads, ATVs and other vehicles where a special, simple and lightweight solution is required
    The holder does not require a separate licence
    For all quads that require 2 rear lights and 2 reflectors, as is the case with open cars or an LOF licence.
    With the length of the holder, the prescribed distances (outer edge of wheel to rear light (40cm)) can normally be easily maintained

--------------------
 
Compatibility:
 
Yamaha Raptor 660, Yamaha Raptor 700, Suzuki LTZ, Yamaha Banshee, Yamaha Blaster, Kawasaki KFX 450, 700, SMC 150, SMC 250, Suzuki LTR 450, Exeet, Dinli, KTM, EATV and many others.