Mikuni Powerjet retrofit kit for TM35-1
Scope of delivery:
1x Powejet
3x Powerjet nozzle (40/50/60)
1x hose connection float chamber
1x connecting hose float chamber to Powerjet
2x seal
2x hose clamp
Why Powerjet?
Quite simply! The additional jet, through which petrol is injected from approx. 1/2 throttle, allows the main jet of the carburettor to be selected smaller. This eliminates the well-known overfuelling at partial load.
(Properly tuned, of course)
What must be observed?
The Powerjetkit must be fitted to the carburettor. This requires a little manual dexterity. In addition, both powerjets should be fitted in exactly the same position.
The following work must be carried out:
- A base must be glued onto the carburettor, onto which the Powerjet is then mounted. This can be done with cold metal, for example.
- The float chamber must be drilled in order to install and connect the brass piece for the hose connection.
- The Powerjet must be fitted to the carburettor. To do this, an additional hole must be drilled in the carburettor through which the Powerjet can be installed in the carburettor air inlet.
Suitable for all TM35-1 carburettors (adaptation necessary)
